IRON FLUXcast-iron searing bench 中文

IFX-029 · Flat griddle · Bake

Flatbread on a cast-iron griddle: 450 °F and a folded cloth

Flatbread puffs because water inside the dough turns to steam faster than it can escape. A flat griddle does this as well as a curved wall, and this run found the exact timing.

· Published · 6 min read

Bench plate IFX-29: rim diameter, wall thickness, handle angle and measured parameters

01Abstract

Eight 80 g flatbreads (300 g flour, 180 g water, 5 g salt, 3 g yeast, 2 h rise) were cooked on a griddle at 450 °F using three regimes: 60 then 45 seconds; 90 seconds without a flip; and 60/45 plus 15 seconds under a folded cloth. Puff height was 22 mm, 4 mm and 26 mm respectively.

02Variables

Independent

  • Finishing regime: plain 60 s then 45 s, a single 90 s side, or 60/45 with 15 s under a folded cloth

Held constant

  • Dough: 300 g plain flour, 180 g water, 5 g salt, 3 g fresh yeast, 2 h rise, divided into 80 g balls and rolled to 4 mm
  • Griddle: flat cast iron, 6 min preheat to 450 °F, no oil on the surface
  • One flatbread at a time, middle of the griddle
  • Cloth: a clean dry tea towel folded twice
  • Puff height measured at the centre within 5 seconds of coming off

Hypothesis A flat griddle puffs flatbread as well as a tandoor-style wall if the surface is hot enough, because the puff is steam and steam only needs a sealed top.

03Process

  1. Mix and knead the dough, rise 2 hours, divide into 80 g balls, and roll each to 4 mm — an uneven thickness means an uneven puff.
  2. Preheat the griddle 6 minutes to 450 °F with nothing on it. A dry surface is what makes the bread grip and puff.
  3. Lay one bread down. Bubbles should appear within 20 seconds; if they don't, the griddle is too cool.
  4. Flip at 60 seconds, cook 45 more, and for the best result cover it with the folded cloth for 15 seconds off the heat.
  5. Stack the finished breads under the same cloth while you cook the rest; they stay pliable for 20 minutes that way.

04Observations

  • 60/45 without a cloth: puff height 22 mm, with 3 large bubbles and 5 smaller ones.
  • A single 90 second side: puff height 4 mm — the surface dried out and set before the steam could lift it.
  • 60/45 plus 15 seconds under a cloth: 26 mm and a fully hollow middle, with the top layer intact.
  • Bubbles appeared at 15 to 20 seconds when the griddle was at 450 °F and at 45 seconds when it had drifted down to 400 °F, so the first visual sign is a usable temperature check.
  • No oil was needed at all: the dry griddle released each bread cleanly and the flour dusting on the dough was enough to prevent sticking.

Instrument log

RegimeFirst bubblesPuff heightMiddleTexture
60 s / 45 s18 s22 mmmostly hollowsoft, chewy
90 s single side18 s4 mmsolidcrisp, flat
60/45 + 15 s cloth17 s26 mmfully hollowsoft, layered

05Conclusion

A flat griddle is enough to puff flatbread fully; what matters is 450 °F on a dry surface and a total of 105 seconds of contact. Adding 15 seconds under a folded cloth off the heat takes the puff from 22 to 26 mm and gives a completely hollow middle, because the top layer keeps steaming instead of setting. Ninety seconds on one side is the wrong answer — the surface sets and the bread stays flat.

Terms used